AT&T PagePac Plus AmpliCenter Installationsanleitung PDF herunterladen (Seite 85)

Computer Monitor Paging Log

Is a PC computer connected to the RS-232 port of the PagePac Plus

Controller for the purpose of logging paging activities? If so, you will want

to program the controller to send signals to it, and turn ON/OFF the

Attendant Access, Telephone Access, and Night Bell signals that would

trigger the monitor to log the event.

Figure A-6 shows a typical computer monitor interface for logging purposes.

For programming information, see section 2 table 2-9 to select the

computer monitor option, and table 2-10 to select default inputs to the

monitor.

Application Notes A-11

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 91 92

AT&T 1
Trademarks 2
Warranty 2
Ordering Information 2
Support Telephone Numbers 2
Contents 3
About This Guide 5
How to Use This Guide 5
Getting Started 6
How to Comment on This Guide 6
Product Ordering Information 6
Reference Materials 6
Overview 7
■ LED Indicators 8
■ Back Panel Nomenclature 8
■ Connectors on Rear 8
About PagePac Plus 9
Security Protection 10
Overview 1-5 11
Managing the System 12
Installing System Hardware 12
Changing System Settings 12
Training Co-Workers 12
Solving Problems 12
Application Notes 13
Features and Capabilities 13
Daily Operation 13
Factory-Set Default Inputs 14
Eight Primary Paging Zones 15
48 Expansion Zones 15
Three Output Types 16
Talk-Back Amplifier 16
Tone Generator 16
Programming Memory 16
Hardware Configuration 16
Indicators and Connectors 17
LED Indicators 17
Back Panel Nomenclature 17
Amplicenter: 18
Controller Unit: 18
Zone Expansion Unit: 18
Overview 1-13 19
Connectors on Rear 20
Interface Considerations 21
Zone Map 22
Table 1-1. Zone Map Example 23
1-18 Overview 24
(Continuation Page 1) 25
1-20 Overview 26
(Continuation Page 3) 27
Zone Configuration Tables 28
Input Zones 29
Programming The Controller 30
Error Tones 31
Introduction 32
Programming by PC 32
At Power Up 33
Enter Programming Mode 34
Reset to Factory Defaults 35
Programming Steps 36
Connect Password 37
Programming Password 39
Forgot the Password? 40
Confirmation Tone ON/OFF 40
Pre-Announcement Tone ON/OFF 41
Talk-Back Warning Tone 42
VOX Disconnect Timing 43
Computer Monitor 44
Input Computer Monitor 45
COPY Command 46
Type of Zone: Input or Output 48
Input Priority Arrangement 49
Zone Monitor 50
Zone Grouping 51
Type of Output 52
Page Enable 54
Music Enable 55
7 ] [ 7 ] and 56
Night Bell Enable 57
Pass DTMF to the Output 58
Tone Selection 60
9 ] [ 3 ] and repeat 61
Tone Routing 62
Audio Source Enable 63
Audio Routing 64
To Enter the 66
Programming Mode 66
The Copy Command 69
Operation 70
Power UP 71
System Administrator 71
End User 71
Within 10 Seconds 72
After 10 Seconds 72
Unlock the Door 72
User Quick Reference Card 73
A-2 Application Notes 76
Background Music 77
A-4 Application Notes 78
Door Control 79
A-6 Application Notes 80
Alarm System Input 81
A-8 Application Notes 82
Talkback 83
A-10 Application Notes 84
Computer Monitor Paging Log 85
A-12 Application Notes 86
Amplifiers 87
A-14 Application Notes 88
IN-2 Index 90

Kommentare zu diesen Handbüchern

Keine Kommentare

AT&T PagePac Plus AmpliCenter Installationsanleitung Seite 85

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audioverstärker AT&T PagePac Plus AmpliCenter