AT&T 9340 Bedienungsanleitung PDF herunterladen (Seite 5)

INSTALLATION

Power cord

Long telephone line cord

Strain-relief

groove

Standard

electrical

outlet

Modular

telephone

jack

The instructions below are for both table and wall installation.

1 Choose a spot near an electrical outlet and a telephone jack.

This phone requires a modular telephone jack and a standard

electrical outlet (110v AC) not controlled by a wall switch.

2 Install the handset battery.

(For an illustration of battery installation, see the BATTERIES section

in this manual.)

• Remove the battery cover by pressing on the indentation and

sliding downward.

• Plug the battery pack connector into the handset, and place the

battery pack and wires into the compartment.

• Replace the battery cover by sliding it on its track up over the

battery compartment until it snaps firmly into place.

3 Connect the telephone line cord.

Make sure the plugs snap firmly into place. (If you are wall

mounting the phone, use the short line cord, and press the excess

cord into the groove on the bottom of the base.)

4 Connect the power cord as shown above.

NOTE: Connect power to the base unit before placing the handset in

the cradle.

AT&T 9340 book_1ATT 11/3/98, 12:40 PM3

1 2 3 4 5 6 7 8 9 10 ... 26 27

Keine Kommentare

AT&T 9340 Bedienungsanleitung Seite 5