AT&T Telephone R1V2 Bedienungsanleitung PDF herunterladen (Seite 117)

1 At Action = , enter 1.

Reassign an RS232

connector function

At Data = , enter the function you want to assign to the

Target connector from the following list:

0 - None (disconnect function)

1 - Admin. (Target 1 or 4 only)

2 - SMDR (Target 2 or 3 only)

3 - Tape (Target 3 only)

4 - Reserved

See footnote* on previous page for default function.

Change length of

Note Unless you’re already administering the Target

RETURN Delay

connector for which you wish to change the RETURN delay,

you must first select a Target connector (by entering t or T

and then entering the appropriate number at the “RS232=”

prompt).

1 At

Action = , enter 2.

2 At

Data = , enter a number from 0 through 2.

The default is 0.

Change Baud Rate Note Unless you are already administering the Target

connector for which you wish to change the Baud Rate, you

must first select a Target connector (by entering t or T and

then entering the appropriate number at the “RS232=”

prompt).

1 At

Action = , enter 3.

2 At

Data = , enter 300, 1200, 4800, or 9600.

See footnote* on previous page for the default data.

15-2 Administering RS232 Parameters

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 155 156

Keine Kommentare

AT&T Telephone R1V2 Bedienungsanleitung Seite 117