AT&T Definity Callmaster II Bedienungsanleitung PDF herunterladen (Seite 28)

Many Lucent Technologies voice terminals, including the CALLMASTER,

CALLMASTER II, and CALLMASTER III, have a button. Use the Mute

feature when you are on a call and want to speak with someone else, but don’t want

the caller to hear. The associated green status light goes on when this feature is in

use.

Mute Feature

To use the Mute feature to

prevent the other party

from hearing you

1 Press

• The light next to goes on, and the other

person cannot hear you

2 Press again to resume your conversation with

the caller

• The light next to goes off, and the other

person can hear you again

Mute

The following information applies only if you have a voice terminal that is equipped

with a display.

If an incoming call arrives while you are active on a call, the current display on your

voice terminal will be replaced with new incoming call information. The identity of

the incoming call normally remains displayed for 30 seconds unless there is another

incoming call, the caller hangs up, or you disconnect. After 30 seconds, the display

returns to the current call information.

Note: The 7405D and 7406D voice terminals must be in Normal mode to receive

Automatic Incoming Call Display data. This requirement is not necessary for 7407D

voice terminals or the CALLMASTER, CALLMASTER II, and CALLMASTER III

voice terminals.

Note: If your display terminal is connected to the DEFINITY ECS G3V4 (or later),

pressing the button, after making a Direct Agent call to (or receiving a call

from) a logged-in EAS agent, will display the extension where that agent is logged in.

Display Features

Inspect

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 45 46

Keine Kommentare

AT&T Definity Callmaster II Bedienungsanleitung Seite 28